Sign channel for fitting signs to posts. Bond using EPIC Track Sign Channel Bonding Tape or rivet the sign channel to your panel and fix sign to post using tamtorque or conventional post clips.
Perfect for road signs!
Please see image... Read more
Sign channel for fitting signs to posts. Bond using EPIC Track Sign Channel Bonding Tape or rivet the sign channel to your panel and fix sign to post using tamtorque or conventional post clips.
Perfect for road signs!
Please see image gallery for dimensions of each size.
2.5m Lengths
Check out the Downloads section below for some handy fitting guides including how to fit Easy Change Banners and how to fit signage to Palisade fencing using sign channel with NO visible fixings!
Dibond Traffic Sheet has a very good tensile strength and impact resistance. The nature of Dibond Traffic is that it is more flexible than Aluminium. To obtain the best use and service life, it is recommended that the support rails, which provide stiffening, are fixed in accordance with the table below.
If a sheet joining section is to be fitted by means of riveting, then the rivet should not be within 15mm of the sheet edge.
Sign Channel should be fixed a minimum of 30mm from the edge of the sign.
Bollhoff / Henrob Rivet Recommendations:
DO NOT rivet within 15mm from the edge of the material
Sign Section Height
Number of Rails
Max Rail Spacing
0.50m
2
400mm
0.75m
3
325mm
0.90m
3
400mm
1.00m
4
300mm
1.20m
4
366mm
1.50m
5
350mm
1.75m
6
380mm
2.00m
7
317mm
2.25m
8
340mm
2.44m
8
335mm
When fixing sign channel by means of a non-penetrating rivet system, a maximum spacing of 150mm should be allowed.
Composite sheet signs will flex more than aluminium signs of the same size until they are mounted on posts, hence it is advisable to store completed signs flat or with support rails vertical to prevent possible damage to the sign facings.
Please note, this item has a cut off time for same day dispatch of 2pm. If you have missed the 2pm cut off and require same day dispatch, please call us on 0800 5 999 059.